Getting Started with DryClip™

  • Fully charge DryClip™ before first use.

  • The DryClip™ app available in the App Store. Android support will follow.

  • Open the app and follow the on-screen steps to connect your device.

  • Attach DryClip™ to a clean, dry diaper, then put clothing on before arming the device in the app.

  • You will receive a notification when a moisture or state-change event is detected.

Settings and Features

  • DryClip™ allows you to adjust moisture sensitivity directly in the app.

    • Low — Reduced sensitivity for active movement or maximum battery life

    • Balanced — Recommended everyday setting for most families

    • High — Maximum moisture sensitivity for earlier detection

  • If your phone was out of range or Bluetooth was temporarily unavailable, DryClip™ can retry advertising after moisture is detected so the alert still arrives.

    Retry intervals can be adjusted in the app:

    • Off

    • Every 5 minutes

    • Every 10 minutes

    • Every 20 minutes

    • Every 30 minutes

  • This is important and actually very cool technology-wise.

    DryClip™ is designed to conserve battery life by remaining in a low-power sleep state whenever possible.

    When armed, DryClip™ enters monitoring mode and wakes only when needed to detect moisture events and communicate with the app.

    Re-arming after a diaper change resets monitoring and helps maximize battery life between charges.

  • Choose when you would like to be notified after moisture is detected.

    Notification timing can be adjusted in the app depending on your preferences and usage needs.

  • The DryClip™ app stores recent monitoring activity and wet event history directly in the app.

    Trends may include:

    • Recent wet events

    • Monitoring sessions

    • Device activity

    • Battery level history

  • Enable notifications to receive moisture alerts instantly on your phone.

    A test notification can be sent directly from the app to verify notification settings are working properly.

  • For best performance:

    • Keep Bluetooth enabled

    • Allow notifications

    • Keep DryClip™ charged

    • Re-arm after each diaper change

  • DryClip™ does not record audio or video.

    Monitoring data remains associated with your app experience and connected device.

DryClip™ is not intended to diagnose, treat, cure, or prevent medical conditions.

Safety & Care

  • DryClip™ is intended for external diaper moisture monitoring only.

    DryClip™ is not intended to diagnose, treat, cure, or prevent medical conditions.

  • • Charge DryClip™ using a standard USB-C cable

    • Use only low-voltage USB power sources

    • Do not charge while damaged or wet

    • Disconnect from power after charging is complete

    • Do not puncture, crush, or expose DryClip™ to extreme heat

    If the enclosure becomes damaged, discontinue use immediately.

  • DryClip™ is designed for diaper moisture detection but is not intended for full water submersion.

  • For best performance:

    • Attach DryClip™ to the lower front of a dry diaper

    • Apply clothing over the diaper to help keep DryClip™ in place

    • Re-arm DryClip™ after each diaper change

  • DryClip™ contains small electronic components and is not a toy.

    • Keep out of reach of children when not attached

    • Do not allow chewing or biting

    • Inspect the device regularly for damage

    Discontinue use if:

    • enclosure cracks

    • device opens

    • battery swelling occurs

    • excessive heat is noticed

  • Store DryClip™ in a cool, dry location.

    Avoid:

    • direct sunlight

    • extreme temperatures

    • prolonged humidity exposure

    Clean only with a soft, dry cloth.

  • DryClip™ relies on:

    • Bluetooth connectivity

    • phone notification settings

    • battery charge level

    Notification delivery may vary depending on phone settings, distance, or environmental conditions.